Search results

The cold water tap on Aqualesa bath/shower mixer is not working. Turning the tap fails to turn the spindle because the two components (the blue one is plastic)in photo 3 do not lock together because of wear (the housing in the inside top of the shroud has cracked badly and the top of the blue...

My PIR is failing to trigger the lamps wired to it at dusk .The PIR is calibrated at the factory and has worked fine for several years. A very slight tap on the base of the unit (NEWLEC NL5601) is enought to get it to work OK., but obviously is not a long term solution. I am a complete...

There are no obvious faults with the machine BUT shirts etc often end the wash with small (say 3mm) stains of reddish rust appearance. Anyone know what problem/solution may be ? Thanks

I have two outside lights controlled by dusk to dawn photocell unit This all worked fine until two days ago the lights didn't go on until midnight,well after dusk.They now do this every day . Nothing new -- no additional outside lighting to affect things. Any ideas ? Thanks Myles

My immersion heater has always produced water which is very hot. I decided recently to try and adjust the heater but could see no controls . In fact I discovered that the cap on the heating unit (located at the top of the cylinder) said " Santon CIRCULATOR ".This unit must be at least 35...

For some reason my diagram in recent message did not display properly.The two vertical lines on left should have been shown to the right, completing the right hand side of the towel rail , showing it as a complete rectangle .

I have a towel rail in the bathroom which gets its hot water from the hot water cylinder , the return being directly back to the cylinder . It is NOT part of the central heating system. As a result of some fiddling with the supply of cold water to the cylinder simultaneously with the running...

Two of my radiators have large cold areas in the middle , stretching to the bottom -- but the top 8 inches are hot. They are over 30 years old but look OK and are not leaking. Do they need to be replaced ? Will it be possible to find exact match , so that fresh pipework etc can be...