Search results

  1. B

    Should I fill the gap?

    Hi All, I took the skirting off to fit an Ikea PAX wardrobe flush to the wall and noticed a large gap between the plaster board and floor. The gap is about an inch. Do you think this should be filled or left as is? I was worried about a draft and a potential for damp as it's against an outside...
  2. B

    Wardrobes flush against wall that backs to outside

    Hi folks, I am fitting wardrobes in an L shape in a room with one of the walls that the wardrobes will be on being against the outside. Should I be concerned about this for damp / mould reasons? I've no reason to believe the wall is damp but I remember in an old house a bookcase I had against...
  3. B

    Sealing gap under skirting

    I recently ripped up my carpet in preparation for a new one. I noticed a few carpet beetle larvae. I caught most of them but one escaped under a gap in the skirting board. There is about 3mm gap between the bottom of the skirting and the floorboard. I was wondering if sealing under the...
  4. B

    Ademco control panel stopped setting properly

    Hi all, I would really appreciate a bit of help here please. I have an alarm box is an ademco xpc microtech accord 8 with the control panel as picture. I had to switch the power off at the circuit breaker and later that night when I went to set the alarm to the "Night Set" (Easy Set 3) it...
  5. B

    Air Brick Please Help

    Hi All. Would love a bit of guidance please. I have a 15 yo house with concrete floors and cavity walls... now filled with insulation from Eon. I have air bricks very close to the ground. All the reading I am doing is taking about these for venting under a wooden floor. A couple of pages talk...
  6. B

    Tamper Light on...

    Hi All, I'd really love some help please... The panel cover on the alarm box in the cupboard was knocked off today and needless to say the tamper went off. The alarm sounded (and was turned off with the code) and the tamper light went on on the keypad but this stayed on after the code was...
Back
Top