Search results

Hi All, I recently added a 3 bar twin booster pump to boost the pressure to all outlets on my vented domestic water system. Its working out very well except the pump cycles on and off after flushing the toilet and also when the dishwasher is filling. Thinking of adding two expansion/accumulator...

Hi All - have to move location of my vented hot water cylinder so am taking the opportunity to install a solar panel. I initially planned to change to an unvented system as most of the pipework is in the attic and got my hands on an unvented stainless steel dual coil 250litre tank at a good...

Hi All, Have a tricity bendix dishwasher model TDF222 - suddenly stopped heating the water but will complete a full cycle. Had a look around - it has a water heater on the intake pipe as opposed to an element in the sump - look this off and connected it to 220v briefly - heated up. Then...

Hi all, I have just been offered a stove with a back boiler and am thinking of using it in the conservatory. However I am not interested in connecting it up to rads etc. Can a stove with a back boiler be operated "dry" without running water through it? Ta in advance.

Hi, The boiler is approx 3 year old and I am having an intermittent fault over the past few few weeks which is getting more frequent. It is controlled by an integrated timer and recently the flame fails to ignite particularly so in the mornings when it is set to come on. The red 30* indicator...

Hi all, I recently installed a stove with a back boiler and installed a dual coil cylinder which is now heated by the existing pressurized gas boiler and the open vented back boiler. I have noticed that even though both heat sources are heating the water at night, the water is cool in the...

Hi all, I am installing a solid fuel stove in my conservatory and because I do not have a chimney, I will be knocking a hole through the cavity wall (twin 4" block) and putting in a double walled insulated flue. The flue will be exiting the stove at the rear and going through the wall at a 45...

Hi all, I'm installing a boiler stove to the conservatory and instead of interfering with the existing pressurised CH system have decided to add two or three rads with open vent F&E tank etc. Most of the pipework is already in the attic including the tank since my old CH system was changed...

It is with great embarrassment that I post this request :oops: . Today while fitting a new dual coil cylinder in the hotpress I overtightened a 1 inch fitting to one of the threaded outlets of the cylinder. Thankfully there was not a major leak as the cylinder was filling at the time. However...

Hi All, Have a whirlpool dishwasher - three years old. Recently after starting a cycle, pump comes on for 10 seconds, then stops and starts cycling on and off every second. The light goes out and back on again each time the pump comes on. Have left it like this for up to an hour and on - off...

Hi All, Have an 18 month oild baxi 60/100 system boiler - at the moment it will not ignite - flashing warning symbol indicates "low pressure or pump fault". Pressure ok and pump running. Manual fault finding chart suggests possible damaged primary flow valve diaphragm damaged or flow valve...

Hi - Whirlpool ADF 4400 dishweasher not completing cycle - green light flashes four times repetedly. Any ideas where the fault lies?/ Thanks