Search results

Hi footprints, Yes the two holes accepted to pins that were on the tap handle. There is then a 3rd hole in between that has a screw up into the handle. From what I see the handle could only be removed by removing the disk and exposing the underside and also the tap valve.:(

Yes various sizes. If you look in the whole you can just see the brass top of the tap valve (the bit with the lines going down)

I know that. It was fitted before we bought the house....

No just a single hole but no screw and when you turn the tap the whole closes up as if it moved with the handle. There is one hole to remove the arm where the water comes out. I'm stumped!

Nope. Not that I can see, just attached the pdf

Instructions sent from Wickes support..

Thank JohnD.Another photo... Yes as above spoken to wickes. I think the tap is about 8 years old. Wickes seem to be selling a few in remaining stock

Thanks Tigercubrider, I have purchased a new tap with a view to using the handle. So I need to get the new handle off and switch it for the broken one on the installed tap. There were no instructions with the new tap so I phoned wickes who emailed me a pdf version however nothing other than...

Hi All, Bit of a dilemma hereo_O. I need to remove the tap handle/head from a wickes Athens bath mixer tap ( due to a broken handle ) and have no idea how to. A plumber has been around and he also didn't know. It's going to be costly as the bath tap is installed lengthways against the wall so...

mointainwalker : I didn't expect anything, all I was after was some guidance on price and if it seemed ok. Anyway, thanks both for the replies.

143 views and no comments? Did I say something wrong!?

Hi All, First of all happy Christmas! I recently asked a builder I often use to price up a single storey extension. In short its approx. 3m x 2.5 that will house a new downstairs loo. It will basically fill the space at the front of the house between the kitchen and the garage. I think...

Hi folks, I am planning of having a new kitchen and bathroom very soon and I am also considering replacing the boiler. As it's approx 15-20 yrs old (Gloworm hide away). I can imagine getting the new kitchen and bathroom installed, both with tiled floor, and then the boiler breaking and then...

Hi, I had the same thing on the first wall i plasted. I am a bit of a perfectionist as well and this made it worse. The light in the room also mad a difference as I had a window on the landing that made light shine sideway down the wall. The low points really stud out. I used a dry wall...

Hi I am in the process of making a light for the home that uses OSRAM LED's and the LED's required a regulator power supply to drive them. From what I can see the Power supply does not come with a plug fitted. I would imagine that they would normally be wired into the lighting circuit but I...

Thanks for the advise. Just the one tank with one supply and one feed. The feed must split after leaving the cold tank to supply the CH/Hot tank. I think the CH was put in after the house was built due to external pipes and a solid floor downstairs. As it uses the same tank it sounds...

Hi, Can a inhibitor be added to an open CH system that feeds from the hot water feed tank? Thanks

Hi, I have installed one radiator and moved another. Now I am ready to connect up to the CH system. I have found the drain valve no problem so I went in to the loft to the expansion tank to secure the ball valve so the system did not fill up while I was emptying the water. This is where I...