Search results

Warm greetings friends. The TRV4 Rad Valve is not responding to the valve and stays hot. The valve pin is working -pressing down and springing up. Any advice will be most appreciated.

Warm greetings. My summer house has rotted/separated where the wooden side meets the wooden floor. The floor is supported under neath so the wooden side has slid down a bit. The result of this is that the wooden double doors have parted by approx' 1.1/2" at the bottom and about 3/4" at the top...

I am fitting some noggins in floor joists. The gap seems to vary slightly as you go. If I cut a noggin that is slightly smaller than the gap, is there some way to wedge it, or do I have to cut another? I thought you could measure once and cut a dozen noggins but....:cry::cry::cry: is there a...

I have a toilet that creaks when you stand on the wooden floor. The planks run cross wise , and the joists the run long ways away fro the toilet. The toilet is over one of the joists. All the plants are well screwed to the joists so I assume it must be the 'bounch' from the joists as you walk...

The toilet started filling slowly - about 5 minutes to fill. I cleaned it all but it looked ok really. I put it back together and it worked first time. However the second flush was slow, and I noticed some of the water was jetting where the float arm joins the valve. It only stops if you close...

The water pressure coming into the house from the mains is approx' 80psi. I was getting knocking in the pipes, after United utilities repaired a leak outside my house and the pressure went up.When you turned taps off in the house and outside tap at the back of the house, the knocking would...

I have received some flags, that are smooth on one side, with small pimples about 1" apart on the other. Do you lay these pimples down?:( Henry.

Is there a reason why squared flags need a gap for grout? Is it just the look? I would have thought flags pushed up together would be more secure??

I had this boiler fitted in 2008. It is an ecoTEC plus 630 VU GB 306/3-5 The recurring problem is the F75 error. I have had numerous sensors & motherboards. The flexibles pipes were changed from flexies to rigid copper. The water in the system is very clean and clear. is there a permanent fix...