Search results

obviously you haven,t done a psi gauge on a broag remeha-----with the gas off , i reduced the water pressure to allow removal, first checked for blockages but line clear, removed the said gauge, fitted new one, and repressurised the system, gas on, 3 minute start phase on boiler, then adjusted...

I have a broag remeha avante plus and I would like to fit a new gauge .......is it a fairly easy job .......the boiler is working perfectly except for the gauge Many thanks Rob

My dishwasher tripped the breaker this evening midway through the cycle, there is still water in the machine. I reset the breaker but there is no indication of power at the on/off switch----new fuse-----but still nothing Anybody have any ideas ?--many thanks Rob

i was bleeding my rads last week as i am getting cold spots on some of them and the water was black, which i believe is not a good sign. What would be the best way to clean the system. (micro-bore) I live in a small house and the rads are not big. I have a broag remeah avante combi boiler...

yes tried to balance all the rads-----i shut off the upstairs rads, and the lower ones did get hotter, but not a lot, i am going to leave the ferox in for a few days, then drain the system, check the TRV'S ---the trv's on the hall rads are very hot, the valve on the big rad in the lounge is...

i have a sealed system with a baxi 105e-----upstairs rads are fine (3off) but downstairs (4) are only slightly warm, so i am thinking of a blockage somewhere, i have just added ferox400, so will leave it for a few days. has anyone experienced this problem Rob

has anyone changed the drum bearings on this type of appliance, if so any tips would be appreciated- many thanx

When i rewind or fast forward i get the circular indication light on the screen and on the box---when i press play the screen light goes out, fine, but the one on the box keeps going----and going, even when i go on to stand by, it still goes on and on---------anybody have any idea many thanks

i have fault on my SL 8 alarm system-----keeps going off on a remote zone, i found a fuse blown but that was not the problem, so i powered down the alarm, as i am going on holiday, ----mains off, battery out, but the bell box still flashing small LED'S, so i disconnected ALL wiring in the box...

i found that my alarm was going off when we were out, so i did a systems test,----- firstly to check the external box, i omitted the only 3 zones i have, then re-set the alarm,----- but it went off again about 30 mins later, indicating zone 7 (red light)---i don't have a zone 7----???? only...

i would like to know which type of freezer is the more economical, one with a small gas compressor or the other with heat distribution coils, or are they both much the same many thanks rob

I am having cavity wall insulation installed soon, the rep came this week and told me that my outside vents would have to be changed. i accepted this but he left before i could ask him why. I have the louvre type vent at the moment. Could anyone advise many thanks

i have had a small leak on my chimney which i have had repaired, I had to cut a hole in the ceiling (dormer bedroom) to view where the leak was, anyway i find that the plaster on the bedroom wall just won't dry out, i have had a heater on it for days and days---- and a dehumidifier for over a...

The room is used. Heating is on. There is ventilation from the downstairs brick vent---i have had the heater on it for days, it seems dry after but the damp just permeates through a short while later--- only on the chimney breast not the surrounding ceiling---had two roofers check it out +...

i noticed damp patches (yellow stains) on my chimney breast on the dormer bedroom--i used a damp meter and had bad readings from the ceiling down to about midway (3 ft) -----i have checked the outside brickwork and pot and all seems fine there, and the internal roof around the chimney breast is...

boiler is working fine but when it fires up about 3am to heat up the internal tank it is really noisy-----runs for a minute and shuts down. When firing up for normal operation at 6am it is as usual nice and quiet. I realise the house is very quiet at 3am but i get wakened up by the noise. Think...