Search results

Ok thanks. If I don't put down some sort of membrane for weed protection won't they eventually come through even type 1 ? Cheers

Loose gravel with a 3 or 4 brick front border. Driveway is jnackered and this for me is the cheaper option

Going to take the hedge down so the bricks will go across the whole width of the house

This is the front of my house to give you an idea.

Hi Looking for some advice. Our driveway is crazy paved and all or most of the pointing has gone. My idea is to take all the Paving up lay a membrane and cover with shingle/gravel. At the entrance I want to put 3 rows of reclaimed house bricks to drive over then the shingle if that makes sense...

Ok,I'm going to have to buy one to do it so off to fleabay I go

No I haven't.Is that the same as a multimeter ?

Thanks again for your help, I managed to get the panel off,all intact and found the block with the 2 black wires by the dispenser and that is all in tact as well. Is there a way to test the heater without a multimeter as I don't have one and is it more likely to be the pcb or the heater ? I...

And the red on light flickers all the time ? Not sure if that has anything to do with it ?

I'm obviously doing something wrong but have taken the 4 top screws off inside the top of the door and cant get the panel to move ? Do I pull it straight up or out

Thanks I'll have a look. I have done a search as well and someone said it may be the heater which I've found for £26 I take it the pcb is dearer. should I replace both and is the pcb something a novice can do ?

Thanks for your help,I don't want to sound like a numpty but could you explain in more detail. what plastic square on what dispenser and how do I remove the consol panel to see the pcb whatever that is. Thanks again

I've just noticed that the 'delicate' light flashes but the machine seems to go through a full cycle,no other lights flashing

How do I do that ? Cheers

Hi,I have a Hotpoint DWF50 Dishwasher and it does not seem to get hot,dishes wash ok,salt and rinse aid always topped up but the glasses come out a bit cloudy and if you open it during a cycle it has cold water not hot.Also the powder doesnt seem to come out of the dispenser properly.It does...

All done,thanks for the help. I've ordered a new fan but it's working at the moment. The motor seems to be making a lot of noise but we will have to put up with that. Sounds like someone is constantly running their finger over a comb ? Have checked and there is nothing caught in it and when you...

I did notice that the heater has 4 (I think) elements and one of them looked like the cardboard they are on has split,will this need replacing or do I need to reset it first and see what happens. I pressume I can't try it until I get the new fan part otherwise it could over heat ? The fan needs...

Thanks ill give it a go. Is this why it goes to f10 quickly

Hi all, I have dicovered the noise from the dryer and am ordering the part today , it's the TUMBLE DRYER IMPELLER RECIRCULATE basicaly the fan for the heater element. Just one question though,when we put the dryer on within 20 seconds it goes to fault code F-10 any ideas ? Thanks

Tape over with I think it's called scrim tape and then fill and sand again ?