Search results

ok thanks will try that !

there's a pipe coming out of the middle of the cylinder which appears to have a airvent on it ? should i open that ? (it appears to be the same as on a radiator)

when i turn the hot taps on cold water comes out... the ch and hw have been on for about 3 hours now... the radiators are working ok... and cold water comes out the cold taps... thanks,

sorry when you turn the hot taps on cold water comes out, the rad's are all working find and i've checked for trapped air, it's a conventional system...

hi, i've got a problem with no hot water being drawn from the cylinder, i've been told i might have trapped air in the coil and i need to remove it. how would i do this ? thanks, dan.

yes it's a conventional system, all the radiators are getting hot and i've got all the air out of them, the boiler heats the hw... thanks...

there's no hot water, i've got water coming out of all the taps, thanks

hi, i turned off the water yesterday and drained down the central heating and then fitted a new radiator in the bathroom and extended the shower pipes (i've put in a new shower) turned all the water back on but no hot water comes through, the boilers working ok and the water tanks in the roof...

bought a towel radiator to fit in the bathroom, house is about 100 years old and i live by the seaside, so most walls i have encountered in the house so far are made up of a mixture of thing, (mainly beach like pebbles). previous experience with trying to hang things on the walls with any weight...

thanks Jason that's a great help... i got a wickes just over the road so i'll either get the aquapanel or some 6x6 tiles... (just need to check which depth i need)

yes it's just a standard single switch, i'll try that... thanks...

yes it's got a L N on the LOAD and a L N on the IN

thanks jason, is there anything that's useable ? only reason i ask is that the local stockist for Wedi board for me is a couple of hours drive. thanks,

i've got a dimmer pull cord for the bathroom but im not sure how it should be wired up. on 1 side it has LOAD and the other IN. i tried it wired up to the IN but it didn't work. is it the LOAD it needs to wired into ? thanks,

i've got some 9'8 x 13'1 wall tiles im putting round the bath (2 high) then a run of 5 of the very small mosaic tiles (the 1's on the webbing backing) then another 2 high over the larger 1's. the mosaic tiles are about half the thickness of the 9'8 x 13'1s. what's the best way to make mosaic 1's...

thanks for that.. i shall pick some up !

i've just fitted a new bath and the waste is leaking very slightly. it's coming out where the rubber seal is onto the bath underneath. could it just be the screw that pulls them togther needs tightening ? i have done it fairly tight but am afraid over over-tightening it and snappning it ? i've...