Search results

Hi, can a gas pipe be laid in a channel in concrete floor and then concreted over? Gas supply to a new hob in kitchen is over the other side of room so need to get supply over there. I'm doing all the prep work before the plumber comes to put the pipes in. So just making sure before I chase...

Ricicle, will they be able to tell me just from the address? Cheers

Cheers, so if I borrow me mates megger tester, switch off circuit. Put tester to loop, test between live (incoming) and the block and get a reading of say 0.25 for example...i have an earth?

//media.diynot.com/39000_38201_52626_92618116_thumb.jpg

Cheers, would a pic help, or would it still need a loop test on it?

Earth

Hi, a friend of mine has had a new meter installed. The installer said to her you need an earth. When I looked at it there are no earth cables visible from the incoming supply casing to an earth block, nothing up to the up to the consumer unit or anything visible out to the gas/water pipes. On...

.....to cut a long story short...my mate and his Dad had installed a new kitchen ring... They couldn't be bothered to terminate the earth at the board so they snipped them instead!!! No earth whatsoever in the kitchen!!!!!! They couldn't understand what the problem was.... I had to...

Cheers Gary.

Hi Gary, it's a 6-way. The house was rewired mid 70's so i assume it was fitted then.

Hi all, for the purpose of a PIR form, does anybody have an idea of the following for an old brown Wylex fuse board? BS, Type No. of poles Current rating Thanks Mike

Cheers fellas.... Breezer, thought of that but scared i might do more damage....if i hadn;t of rubbed the ash in it might have worked...but not prepared to take the chance... JohnD, thanks for the link...just what i need.

Hi..... I made a stupid mistake of dropping ash on an expensive print i recently bought. I tried to wipe it off and rubbed it into the paper :oops: It's not highly visible but the fact i know it's there is annoying me. Anybody have any ideas on how to remove it? Thanks in advance.

"Had relevent training"...."just lazy".... enough said!!! But...no disrespect......brown book pretty important!

no disrespect but, are you a spark or plumber.....?? If you are a spark (or even a plumber and your doing this type of work)...should you not know the answer to your own question....pretty fundamental i think?

Make sure you know which is the switch cable and mark it up with some red sleeving or red insulation tape.

The answer to your question lies here: //www.diynot.com/wiki/electrics:lighting:rose However, if you do not feel confident in performing the task then i'd consult a qualified electrician. When you dismantled at the ceiling rose did any of the the black/blue cores have any red/brown...

Hi Adam, yes the ECA are now affiliated with CSCS. When i contacted the JIB enquiring about an ECS card he told me i only had to take the Electrical H & S Assessment and once passed to send them my C&G and EAL certificates and they would issue me with a card. Just wondering if it's...

Hi Guys and Gals, just gained my 2381 and DI qual. Not one of these fly by night ones either, it took me almost 2 years of very hard work. A spark i know is letting me get on the tools with him to gain some valuable experience. I contacted CSCS to apply for a card. I was told that i had to go...