Search results

Hi all I'm sure you are fed up with being asked this but I am a complete novice and the thought of what I am about to start scares the living wotsits out of me.. We have just started the process of an extension project on our house. Its a side kitchen extension, going up one level to double...

Does anybody know if I can remove the Diaphragm assembly for a Impils360 bottom fill valve. My cistern continues to trickle when it is full and I believe bubbles may have formed on the diaphragm. If anybody can easily explain it it would be great. Thanks

Hope somebody can help. First of all I have no idea what I am talking about so please bear with me. I have what I believe is a Geberit Impuls 360 bottom filling valve that is overfilling after a flush. I cannot find anywhere on line that can tell me how to fix it so I am tempted to go and buy...

Can you add chemical clean and inhibitor at the same time

There was quite a bit of muck come out when i drained the rail

Thanks for that, I havn't fitted the new rail yet anyway, I will drain it and put the inhibitor into the rail before filling the system back up. Cheers for that

Thats the thing I havn't tried yet, will it work if I put the inhibitor into the new towel rail will the heating pump it around the system

Can somebody help, I have a combi boiler. Recently I installed a chrome towel rail in the bathroom, however within a year it had rusted quite badly. The manufacturers did change it although they recommended I use a central heating inhibitor. Looking up on the internet it recommends I put the...

Thanks for the advice everyone, I think I will call an engineer out, I am about as technical as a broken ruler... I had a look last night and the pressure went to 3 1/2 when everything was off, it seems to go down when the heating is on, but up when everything is off..

The filling valve isn't open, how does it keep increasing, is that a fault, also where can I drain it and is it essential I do it as you can tell, I havn't a clue about boilers..

I have an old style Worcester 24i boiler installed. My red needle on the pressure guage is set to about 1 1/2 however the actual pressure needle usually runs at around 3 . Does anybody know if this is right, and if not how do I reduce the pressure in the system