Search results

Hi folks, could someone offer advice on where to start with no hot water from the above boiler? CH works fine but when I run the hot water tap it fails to initiate any demand. If the CH is on when I do this it diverts to the hot water top but if the CH isn't on then I get no hot water..... Any...

Hi folks, wondering if anyone might be able to help me with the connections on the above boiler (I understand that the company went bust!) Basically I'm wanting to switch the boiler on and off via the low voltage connections (24v) can anyone help me identify the terminals? I think that the ones...

Hi, hoping for a bit of direction on this one folks! I have an Eco Hometec (MAN) condensing combi boiler at home. However I've noticed that when I run the hot water and then turn off the tap the boiler continues to fire for approx. 20-25 seconds and appears to dump the unwanted hot water into...

Hi folks, I'm after a bit of advice on the above boiler. Essentially the central heating all works spot on but the hot water flow rate is really poor from all three hot water taps. What could be the problem? I'm competent enough and have replaced pcbs pumps and diverter valves on an alpha...

Hi folks, hope you can help. My Triton Bezique 2 shower has a low flow rate problem. The water heats fine, the water pressure to the sink off the same feed is fine, the shower head and hose are fine too. It's just that there is a poor flow of water from the shower even when I select cold...

Hi, I have an Alpha CB24 and the neons are flashing when there is demand for hot water. They flash alternately which according to the manual means that there is low pressure, however the pressure guage is sitting pretty at just over 1 bar. I've heard that the pressure switch may be at...

Hi, I need a spot of direction folks. I have an Alpha CB24 combi on a single pipe system in a three bed semi with loft conversion. The upstairs rads get lovely and hot but the downstairs rads are barely warm at all. Is this likely to be sludge in all the rads downstairs or a pump issue? I'm...

Hi, we have an Alpha CB24 combi in a 3 bed semi plumbed to 9 rads on a single pipe system. The trouble is that in order to get any real heat from the rads downstairs we have to turn up the stat on the boiler front to full. What I don't understand is that the rads upstairs work perfectly well...

Hi folks, I could do with a spot of advice on this one as I'm no expert with showers apart from installing one. It has worked fine for the last 2 years but now has the low pressure warning light on and as such will only run cold. the water pressure is fine all round the house and I've checked...

Hi folks, I was wondering if anyone could help me on this one. The hot water basically doesn't get hot enough (i.e. when I run a bath the water is just luke warm) even if I adjust the HW temp setting to the highest setting (point 9) Just for info, the water does increase in temperature if I...