Search results

  1. C

    Kitchen End Panel Size

    The kitchen is from the IT range at B&Q and is in the Contemporary Maple Style.
  2. C

    Kitchen End Panel Size

    HI I am in the process of fitting a B&Q kitchen. I have a question about the base end support panels. The Panels supplied are 570mm wide (the same width as the base unit carcas itself). I was under the impression that the end support panels were supposed to be 600mm wide so that when fitted...
  3. C

    Lights for a Shallow Ceiling Void.

    Hi I am currently renovating a kitchen in our 1840s house. The kitchen is in a single storey extension with a pitched roof. I wish to install downlights into the ceiling however the depth between the plaster board and the felt which lies under the external roof slates is only 75mm. I intend...
  4. C

    Alpha 240 boiler

    Yes bill was itemised £93 To find fault (1.5hrs + travel) £122 To replace part (2hrs + travel) £124 for new heat exchanger £90 for Magna Clean £14 for replced sensor. + VAT for Mr Brown!
  5. C

    Alpha 240 boiler

    Brummie I have recently had exactly the same problem on my Alpha CD24C boiler. We called out a local Alpha specialist who tracked the fault to the Domestic Hot Water Heat Exchanger. The problem was a build up of sludge restricting the flow. One new heat exchanger & one magnaclean later & the...
  6. C

    FLOOR DRAUGHTS

    Thanks for the advice Topper. There appears to be enough room to get below & fix insulation to the underside of the floor so think that I will do this in the next couple of days. Which insulation would you recommend. Would polystrene sheets do the job? Do I need to be concerned about...
  7. C

    FLOOR DRAUGHTS

    I am about to sand the floor boards in our living room and want to know if there is anything I can do to stop the draughts coming through the joins in the boards. The boards are in excellent condition and the gap between each floor board is less than 1mm through out the room. yet still the...
  8. C

    SHOWER MIXER - PIPES TOO SHORT

    I have recently fitted a Mira Shower mixer. The hot & cold feed pipes were recessed into the concrete wall and then tiled over. I have now discovered that I have not left enough pipe work exposed from the wall. The mixer is sat too close to the wall making it impossible to fit the chrome...
Back
Top