Search results

A friend of mine wants to move his CH pump (i don't know why) and i was wondering if this is a relatively straightforward job that he could do himself?. I assume he would need to drain down his ch circuit to below level of pump, undo the nuts, remove pump, alter pipework and remount the pump...

I am taking a 1 1/2 pushfit waste pipe for a washing machine through a partition wall. Would an holesaw be must best option to get a nice clean hole or would you have another suggestion??.

lol, slightly comflicting advice there. I was thinking of renewing the waste for the basin also, but as this runs behind the bath that would involve a lot of extra work. So will the 32mm be ok ?

I want to move my washing machine out of the kitchen and into a small cubby i have to make more room in the kitchen. I am wondering if i can run my washing machine waste into the basin waste pipe which is in the adjoinning room ?. Iam thinking of using a stand pipe and taking the pipe through...

Can anyone provide me with help pulling passover and offset bends please. Looking to improve my pipe bending and need any advice or tips on how to improve in this area.

Just a general question Softus, no relation to any problems i have with my system.

is there such a thing as a partially pumped system? Gravity circulation soley relies on the forces of gravity and convection currents to circulate water around the system, without the use of a pump and zone valves/cyl stat or room stat?

just wanted to know how you plumbers define - Fully pumped system

When wiring in 2x2 port valves what does the term " switch live " mean?, can it be any colour cable but labeled up as a live?. any other info on wiring heating controls in terms of terminology most welcome.

I have just started my level 3 plumbing course and we are now wiring in heating systems. What i would like is a basic electrical book i can purchase which is for the beginner , explains terms and gives examples of wiring situations. A really beginners book really. Any help greatly appreciated.

Which way do you wrap PTFE tape around a thread. Is it the same direction that you screw the valve body into the rad , or is it the opposite way?. any help would be appreciated.