Search results

  1. A

    lighting problems

    shall i turn gas off out side? cant c anything accessable on boiler. tryed it b4 got this msg with gas turned on to boiler but think its safe due to safty cut out. plus water dripped on my switch panel nice1 just got pop out 4 hour do it wen get bk. any other tips i mite need plz drop...
  2. A

    lighting problems

    how did he bleed it
  3. A

    lighting problems

    not banging or grinding or anything. but it sounds like it is a bit noisier than useuall
  4. A

    lighting problems

    just turned it on again n it lasts for 10 secs b4 goin out. wot sounds like the pump still runs tho
  5. A

    lighting problems

    they dont flash wen i just turn it on. but if i try pressin the red lighting button just 4 1 sec then the ch flashes but if i hold the red button in again for 2 secs then the flashing stops n sum times the boiler will lite, n then like i sed it just goes out with the piolet lite with no other...
  6. A

    lighting problems

    iv got 4:- power, ch, tap w, pilot or wot ever it is. obvouisly my powers on, and the ch n tapw come on wen there in demand, n the piolet comes on briefly n goes out wen the flame does in couple of secs
  7. A

    lighting problems

    had a fault with heat exchanger so changed that, then preasure kept goin up while ch was on, so iv pumped it up the expansion vesel up 2 0.7 of a bar. (followed correct steps with link i as forwarded). now my boiler wont light. wen it does it goes out in bout 5 seconds. then wont light 4 a...
  8. A

    ch preasure going up to and over 3 bar.

    thaks dudes i will check how many units worth iv used next week.
  9. A

    ch preasure going up to and over 3 bar.

    all sounds obivious to me now. iv got 3 bed semi n i av heatin on between 2 n 4 hous at nite n i av worked out that iv used 25 quid in a week. thats with my thermostat set to just 13 oC n my boiler on 3 out of 4
  10. A

    ch preasure going up to and over 3 bar.

    so do u guys think it could cause exsessive fuel comsuption
  11. A

    ch preasure going up to and over 3 bar.

    come from broke on trent dude
  12. A

    ch preasure going up to and over 3 bar.

    yeh yeh nice 1 4 v comments lads. do u think that could cause exsessive fuel comsuption
  13. A

    ch preasure going up to and over 3 bar.

    n was part is that n wot do i do to it? sum1 has mentioned that red round drum with a car tyre valve needs pumping up. is that true? there is no preasure in there at the moment.
  14. A

    ch preasure going up to and over 3 bar.

    rencently i have had new heater matrix fitted due to a pin hole in the old 1 which ment my ch was getting topped constantly up by my mains water, so i was getting over 3 bar and water constanly dripping out side. now iv had the new heater mattrix fitted, the constant dripping of water out...
Back
Top