Evening all.
Anyone come across this? I've just completed 2382-10 and it came up in a discussion...
Table 54.7 in 17th Edition (haven't got 16th to hand but I don't think it has changed) relating to 543.1.4 (cross section selection for CPC) show that where S (cross sector of line (urgh... that is never going to stick!) ) is <= 16mm, then the protective conductor (assuming same material) should the same as the line conductors.. i.e S
On that basis, 1.5, 2.5 etc T&E doesn't comply (2.5 + 1.5) and can't have done for any 16th edition installs..
Apologies if this has already been covered, just curious what people think..
Anyone come across this? I've just completed 2382-10 and it came up in a discussion...
Table 54.7 in 17th Edition (haven't got 16th to hand but I don't think it has changed) relating to 543.1.4 (cross section selection for CPC) show that where S (cross sector of line (urgh... that is never going to stick!) ) is <= 16mm, then the protective conductor (assuming same material) should the same as the line conductors.. i.e S
On that basis, 1.5, 2.5 etc T&E doesn't comply (2.5 + 1.5) and can't have done for any 16th edition installs..
Apologies if this has already been covered, just curious what people think..