Did that, but as the bead is cut at an angle, including the tongue, so it is not visable.
I can only do it when there is nothing in the way, like the glazing panel.
Once I've got any of the beading in place, but want to slide along the frame to make sure the corners are in the correct position, it becomes impossible to move. It is firmly stuck against the glazing panel, like it's really squeezing it?
Hence my thought that the panel is too thick even though it's only 28mm?
I can only do it when there is nothing in the way, like the glazing panel.
Once I've got any of the beading in place, but want to slide along the frame to make sure the corners are in the correct position, it becomes impossible to move. It is firmly stuck against the glazing panel, like it's really squeezing it?
Hence my thought that the panel is too thick even though it's only 28mm?