Hi everybody with reference to previose post from me still got problems.
I still keep having the Tamper fault showing very intermittent sometimes also at night . If I just enter usser code and reset problem cured till the next time as this is getting to be a pain having to get out of bed in the early hours to reset.
Today I decided after seeking help on Internet to remove the control box cover to find the outside bell box tamp, I had previously removed the wires from the keypad and terminals 19 & 20 and fitted link wires into these connection on circuit board.
On main board identified scb terminals T&A connected a link wire on these terminals leaving wires still connected closed lid. I then proceeded out of loft ( main box up there ) to find full alarm now going off outside entered my usser code but would not silence used engineer code still going back up to loft disconnected my link . Back to Keypad applied usser code alarm still not sillencing after many attepts using my code or engineer code eventually stopped ?? Don't know how.
The alarm now does not work outside no strob no bell. Everything in house working o/k
Can anybody tell if I have messed up the bell box by putting the T&A link wire in without dissconecting the wires first
Is there any way I can get this operational again sorry for the long post just wanted to explain in detail what I had done.
Buzzy
I still keep having the Tamper fault showing very intermittent sometimes also at night . If I just enter usser code and reset problem cured till the next time as this is getting to be a pain having to get out of bed in the early hours to reset.
Today I decided after seeking help on Internet to remove the control box cover to find the outside bell box tamp, I had previously removed the wires from the keypad and terminals 19 & 20 and fitted link wires into these connection on circuit board.
On main board identified scb terminals T&A connected a link wire on these terminals leaving wires still connected closed lid. I then proceeded out of loft ( main box up there ) to find full alarm now going off outside entered my usser code but would not silence used engineer code still going back up to loft disconnected my link . Back to Keypad applied usser code alarm still not sillencing after many attepts using my code or engineer code eventually stopped ?? Don't know how.
The alarm now does not work outside no strob no bell. Everything in house working o/k
Can anybody tell if I have messed up the bell box by putting the T&A link wire in without dissconecting the wires first
Is there any way I can get this operational again sorry for the long post just wanted to explain in detail what I had done.
Buzzy