Hi Guys,
I'm looking at running a cold water feed from the kitchen to the utility room. Its about 5m away from the washing machine feed so I was thinking of fitting a 'T Junction' connection of 15mm speedfit to the existing speedfit pipework. From the t Junction I'm planing on running down the wall, along the skirting board and through the wall, then using an elbow round the corner, to the dishwasher.
I think I'm going to need 5.5m pipe, dishwasher tap, 2 x equal elbow, an equal T Junction.
Do you think 15mm is enough or should I be looking at 22mm? Will a run of 5.5m with 2 bends in be acceptable?
I'm looking at running a cold water feed from the kitchen to the utility room. Its about 5m away from the washing machine feed so I was thinking of fitting a 'T Junction' connection of 15mm speedfit to the existing speedfit pipework. From the t Junction I'm planing on running down the wall, along the skirting board and through the wall, then using an elbow round the corner, to the dishwasher.
I think I'm going to need 5.5m pipe, dishwasher tap, 2 x equal elbow, an equal T Junction.
Do you think 15mm is enough or should I be looking at 22mm? Will a run of 5.5m with 2 bends in be acceptable?