Hi
I currently have a Husky ASHP installed at home. We bought the house 18 months ago and the system was already installed. The system is an intelligent i16
I had the ASHP serviced back in May and an actuator valve changed as some of the radiators were not going off with the rest of the heating
Last night the pressure dropped to about 0.6/0.7 bar so i took it upon myself to increase the pressure to around 1.5 bar and since ive had an issue with the radiators all over the house not warming up.
I have two thermostats one up and one down stairs. They are set on 20 degrees yet both show room temps at 15 degrees but still no radiators on.
I have bled each radiator slightly to bring the pressure back down
I have switched the whole unit off and back on again
I have changed the control panel multiple times to either auto or just heating and still nothing
Hot water is fine
We have a 1 year old and the house is cold, I'm stuck as to what i may have done by filling the boiler and increasing the pressure and how to resolve
Any advice appreciated
Thanks
I currently have a Husky ASHP installed at home. We bought the house 18 months ago and the system was already installed. The system is an intelligent i16
I had the ASHP serviced back in May and an actuator valve changed as some of the radiators were not going off with the rest of the heating
Last night the pressure dropped to about 0.6/0.7 bar so i took it upon myself to increase the pressure to around 1.5 bar and since ive had an issue with the radiators all over the house not warming up.
I have two thermostats one up and one down stairs. They are set on 20 degrees yet both show room temps at 15 degrees but still no radiators on.
I have bled each radiator slightly to bring the pressure back down
I have switched the whole unit off and back on again
I have changed the control panel multiple times to either auto or just heating and still nothing
Hot water is fine
We have a 1 year old and the house is cold, I'm stuck as to what i may have done by filling the boiler and increasing the pressure and how to resolve
Any advice appreciated
Thanks