Hi all,
Firstly - I am not looking at doing tips work myself, we have a BG plan.
Our CB50 is showing a Temperature Sensor Fault, and the symptom is that we are only getting HW from the storage cylinder, when it is gone it takes a while to get back up to heat - the combi part is not kicking in. Looking through the installation manual, it has two sensors, one on the tank and one in the room sealed chamber and it says that the sensors are the same.
All I am asking is if these are generic sensors or special Alpha sensors - ie will the BG engineer have it in his van or at the depot - and won't be a special order as we have been caught by this before with this boiler?
Cheers
Bob
Firstly - I am not looking at doing tips work myself, we have a BG plan.
Our CB50 is showing a Temperature Sensor Fault, and the symptom is that we are only getting HW from the storage cylinder, when it is gone it takes a while to get back up to heat - the combi part is not kicking in. Looking through the installation manual, it has two sensors, one on the tank and one in the room sealed chamber and it says that the sensors are the same.
All I am asking is if these are generic sensors or special Alpha sensors - ie will the BG engineer have it in his van or at the depot - and won't be a special order as we have been caught by this before with this boiler?
Cheers
Bob