Hi Guys, been reading a lot on here about the 105e not firing up when hot water is in demand, and the main culbrit being either the DHW flow switch or diaphragm. wondered if someone could advise on my scenario.
Turn on Hot water, metal pin pops out of both diaphragm bits located bottom left hand side of boiler (i have 2 of these thingys) and boiler fires up, all seems well. water gets hot for a second then goes luke warm, regardless of which setting the boiler is on, CH+HW or just HW you get the same result.
I think i have captured everything, can anyone advise please and if you do reply do it in lamens terms as im a little thick when it comes to boilers.
Really appreciate your time..
Turn on Hot water, metal pin pops out of both diaphragm bits located bottom left hand side of boiler (i have 2 of these thingys) and boiler fires up, all seems well. water gets hot for a second then goes luke warm, regardless of which setting the boiler is on, CH+HW or just HW you get the same result.
I think i have captured everything, can anyone advise please and if you do reply do it in lamens terms as im a little thick when it comes to boilers.
Really appreciate your time..