Hi all, great forum..
Advice please, i have a Baxi 105e (about 3-4 years old).
Last night whilst my wife was filling the bath the hot water went cold, i checked the error lights and the fan/flue light was showing. I switched the bolier on/off again and i worked for a very short time and the same fault re-appeared, i just get the fault light now.
Looking through the docs it appears to seem pretty straight forward for fault finding the obvious. The Pressure switch is working (very gently blowing/sucking on the tubes makes the microswitch click (electrical continuity is confirmed whilst i did this.
No AC Voltage on the fan terminals and none on pin 5 & 7 on A5 on the control board. The manual says replace the cct board!
Anyone have a cct diagram? the board appears very straight forward.
Are there any more tests i can do before getting a new cct board?
Is this is common fault on Baxi 105e?
Any advice would be greatly appreciated.
Mank thanks in advance!!
Cheers
Benn
Advice please, i have a Baxi 105e (about 3-4 years old).
Last night whilst my wife was filling the bath the hot water went cold, i checked the error lights and the fan/flue light was showing. I switched the bolier on/off again and i worked for a very short time and the same fault re-appeared, i just get the fault light now.
Looking through the docs it appears to seem pretty straight forward for fault finding the obvious. The Pressure switch is working (very gently blowing/sucking on the tubes makes the microswitch click (electrical continuity is confirmed whilst i did this.
No AC Voltage on the fan terminals and none on pin 5 & 7 on A5 on the control board. The manual says replace the cct board!
Anyone have a cct diagram? the board appears very straight forward.
Are there any more tests i can do before getting a new cct board?
Is this is common fault on Baxi 105e?
Any advice would be greatly appreciated.
Mank thanks in advance!!
Cheers
Benn