Hi, I recently installed a new rad and was going to add some inhibitor in the system when I realised the water was very dirty with particles in it.
Although everything seems to work ok, I want the system to be set up right to limit the possibility of issues in the future.
The products I have are Sentinel X100 Inhibitor and Sentinel X400 Cleaner. The process I was thinking of following is:
I'm a DIYer and have limited experience with plumbing so any advice is much appreciated
Although everything seems to work ok, I want the system to be set up right to limit the possibility of issues in the future.
The products I have are Sentinel X100 Inhibitor and Sentinel X400 Cleaner. The process I was thinking of following is:
- Partially drain system from downstairs through drain off valve then open a towel rad upstairs and add Sentinel X400 - then run the system for a week.
- Drain system as much as possible. Then with the drain off open I could open the filling loop to force any crud out the system? Would this work?
- Close all valves, refill system and add Sentinel X100 Inhibitor
I'm a DIYer and have limited experience with plumbing so any advice is much appreciated
Last edited: