- Joined
- 15 Jul 2018
- Messages
- 200
- Reaction score
- 8
- Country
Hi all,
I'm fitting a new free standing bath tap which has the flexible tails pre connected with a female 1/2" connector on the end.
I have my hot and cold feeds under the floor. The maximum hole i can make for the tap is only about 50mm in diameter so impossible to connect (or disconnect in the future) the pipes to the tap without either cutting a hole in the floor boards next to the tap or from the kitchen ceiling below.
It's not a problem doing the initial connection, but I would like the option to be able to disconnect the tap from the hot/cold pipe in the future if I need to replace the tap without ripping the floor up or damaging the ceiling below.
Any suggestions?
Thanks
I'm fitting a new free standing bath tap which has the flexible tails pre connected with a female 1/2" connector on the end.
I have my hot and cold feeds under the floor. The maximum hole i can make for the tap is only about 50mm in diameter so impossible to connect (or disconnect in the future) the pipes to the tap without either cutting a hole in the floor boards next to the tap or from the kitchen ceiling below.
It's not a problem doing the initial connection, but I would like the option to be able to disconnect the tap from the hot/cold pipe in the future if I need to replace the tap without ripping the floor up or damaging the ceiling below.
Any suggestions?
Thanks