I'm going to tile the top of a sink unit with 400mm x 400mm natural slate tiles. The width of the unit is 400mm. How would I obtain the best corner finish using these tiles on the external corner - between the top of the surface (horizontal) and the 200mm high vertical pelmet.
The edge of the tiles supplied are nicely cut and quite smooth. I don't want to use a corner bead if possible. Is it just a case of butting them up to each other and leaving the edge showing so it is flush with the tile that sits beneath it - and if so I assume I would leave the horizontal face exposed.
The edge of the tiles supplied are nicely cut and quite smooth. I don't want to use a corner bead if possible. Is it just a case of butting them up to each other and leaving the edge showing so it is flush with the tile that sits beneath it - and if so I assume I would leave the horizontal face exposed.