the boiler does not fire up when the upstairs water runs unless you run the bath too.I'm waiting for the diaphram etc to be looked at but now the boiler has started locking out .Is this all part of the same problem?
biasi 24s keeps locking out,no dhw upstairs?
- Thread starter chappie7
- Start date
Sponsored Links
got me there? what are the signs of overheating?
Sponsored Links
if its flame lockout is that a similar job? and is the lockout coming from the dhw problem i mentioned first.The boiler resets for a while then locks out again-the light that comes on is orange if that makes any difference.
It sounds as though the boiler is at best in desparate need of a service, at worse you have a severe clog in the fan/flueway/somewhere.
Get a CORGI guy round to give it a good once over. Gas should never burn a yellow flame.
Get a CORGI guy round to give it a good once over. Gas should never burn a yellow flame.
- Joined
- 21 Oct 2006
- Messages
- 59
- Reaction score
- 1
- Country
Dan_Robinson said:
When you reset the lockout does the ignition cycle start with the burner light on or off (green light on panel) and does the boiler fire up and then lockout or lockout straight away ?
Is the green panel light flashing fast or once every few seconds ?
voiceofthemysteron said:Dan_Robinson said:
When you reset the lockout does the ignition cycle start with the burner light on or off (green light on panel) and does the boiler fire up and then lockout or lockout straight away ?
Is the green panel light flashing fast or once every few seconds ?
Um..wrong boiler mate
B
Bambergaspipe
Stop quoting engineers & come back when you have a f*ucking clue.
be novel if you had lemon
Was looking at two screens - but the point is still valid... Hang on, I was lookiing at the right screen... VOTM needs reading lessons...
- but the point is still valid... Hang on, I was lookiing at the right screen... VOTM needs reading lessons...the boiler now keeps locking out totally,no dhw,no heating and just a day before it was going to be looked at.Is all this because of the diaphram -seems strange?????
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
