I have a Biasi M110.32 SME. It had a new fan recently....worked OK for a while. Now if you call for hot water or central heating the fan starts, you can hear the clicking from the spark generator but then after 2 or 3 seconds it all stops & the central of the three LEDs lights red with the other two LEDs off. I can't see this fault in the manual, any ideas?
BIASI M100 not igniting
- Thread starter AndyMolensky
- Start date
Sponsored Links
So the lockout light doesn't come on? The light to the right of the reset button?
No lockout, just the centre LED, after a few seconds this goes out and the whole cycle repeats until you turn off the boiler or stop calling for heat of DHW
Sponsored Links
It is likely to be an ignition fault although the indication is not correct.
So it needs a gas reg engineer to correct the fault preventing it from ignition.
The PCB may also have a fault.
If the PCB is faulty which sounds likely then a fixed price Biasi repair may be better.
If the PCB is not faulty, or the fault will still allow the boiler to work, then an independent should be cheaper.
Tony
So it needs a gas reg engineer to correct the fault preventing it from ignition.
The PCB may also have a fault.
If the PCB is faulty which sounds likely then a fixed price Biasi repair may be better.
If the PCB is not faulty, or the fault will still allow the boiler to work, then an independent should be cheaper.
Tony
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
