Hi,
I have a Swiftflow Gloworm Boiler.
Just today I tried to run hot water and had none. The boiler had been fine upto this morning.
I checked the boiler and the pilot light had gone out. I re-lit the pilot light, waited a few minutes and tried the hot water again.
I DID turn the valve back to the correct setting!!!!
There was an initial burst of flame in the boiler and then the flame was extinguished.
I then had to wait to re-light the pilot.
This happens everytime the I try to run Hot water/central heating
Any help would be greatly appreciated
I have a Swiftflow Gloworm Boiler.
Just today I tried to run hot water and had none. The boiler had been fine upto this morning.
I checked the boiler and the pilot light had gone out. I re-lit the pilot light, waited a few minutes and tried the hot water again.
I DID turn the valve back to the correct setting!!!!
There was an initial burst of flame in the boiler and then the flame was extinguished.
I then had to wait to re-light the pilot.
This happens everytime the I try to run Hot water/central heating
Any help would be greatly appreciated