Hi. I have a Bosch Classixx washing machine model WAE28368gb that keeps tripping the power circuit during wash cycles. It starts off filling the machine then cuts out after a few turns and sometimes even before it starts to spin. If I turn the mains power back on the washing tries to continue but trips again almost straight away.
I manage to get the washing machine to empty the water & open the door if i turn it to spin, rinse or drain. It spins without cutting out even on the superquick 15 minute setting with rinse hold. Only the wash cycles make the machine cut out. Cold cycle, fast cycle and normal 40 degrees all make the machine cut out. I have tried replacing the plug fuse & used different sockets. Also I didn't detect much rubbish in blocking the drain valve at the bottom right. The machine is under 4 years old.
I can do general electrical repairs and troubleshooting & I am able to replace any part required. I've done basic checks for loose wiring. It doesn't seem like a major fault to have to throw it away or even spend loads on paying an engineer plus parts.
Any suggestions would be appreciated. Thanks
I manage to get the washing machine to empty the water & open the door if i turn it to spin, rinse or drain. It spins without cutting out even on the superquick 15 minute setting with rinse hold. Only the wash cycles make the machine cut out. Cold cycle, fast cycle and normal 40 degrees all make the machine cut out. I have tried replacing the plug fuse & used different sockets. Also I didn't detect much rubbish in blocking the drain valve at the bottom right. The machine is under 4 years old.
I can do general electrical repairs and troubleshooting & I am able to replace any part required. I've done basic checks for loose wiring. It doesn't seem like a major fault to have to throw it away or even spend loads on paying an engineer plus parts.
Any suggestions would be appreciated. Thanks