Hi,
I've just swapped the carbon brushes on my machine. Started ok , which I was really chuffed about but.....
There is a buzzing noise when the drum revolves. I suspect bearings on the way out as it's seen a hell of a lot of action, but was wondering what the symptoms were of brushes being put in the wrong way around ? thinking maybe the pointy end could be just catching the motor as it spins. I'm new to all this and this is the first time I've ever swapped carbon brushes in anything. I'm pretty sure I did it right, but was just wondering about what the symptoms of brushes put in the wrong way round are? - I've done lots of searches but can't find anything out?
Any advice gratefully received?
Thanks,
Dave.
I've just swapped the carbon brushes on my machine. Started ok , which I was really chuffed about but.....
There is a buzzing noise when the drum revolves. I suspect bearings on the way out as it's seen a hell of a lot of action, but was wondering what the symptoms were of brushes being put in the wrong way around ? thinking maybe the pointy end could be just catching the motor as it spins. I'm new to all this and this is the first time I've ever swapped carbon brushes in anything. I'm pretty sure I did it right, but was just wondering about what the symptoms of brushes put in the wrong way round are? - I've done lots of searches but can't find anything out?
Any advice gratefully received?
Thanks,
Dave.