when i turn the hot water on it gets warm and then goes cold. i have to reset the boiler and then it can be fine. sometimes have to reset it 2-3 times a day. i have found that lots of ppl have this problem but i have not found how it was cured. any ideas?
assuming the heating is working then i'd say no.
From the description of the problem it would have to be fluctuating. Very unlikely however simply feeling where the heat goes would prove it.
The most common fault on these boilers is the NTC's. Proved simply by swapping the leads over,
yeah ok you told the guy to swap the leads over but you never told him which leads he,d have to swap so swapping leads is pie in the sky to himwhy did you not mention swapping to the other ntc.and does he know what an ntc is
yeah ok you told the guy to swap the leads over but you never told him which leads he,d have to swap so swapping leads is pie in the sky to himwhy did you not mention swapping to the other ntc.and does he know what an ntc is
S'funny - GasAid seems to think that the HX is blocked and/or scaled. [/quote]
Yes it probably is...but for some reason you asked about the diverter as be though had encountered a problem on these yourself. You try and be helpful....
the central heating works all the time its just the hot water.
thanks for the help. just wondered what sort of job is it to replace the heat exchanger.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local