Hello all,
I am replacing an old APL lifestyle LP241 programmer with a new Heatmiser TM4 touchscreen. On the old timer plate has wires for L, N, HW on, HW off and CH on (CH off wire is not connected for some reason) although it all works as it should.
The new programmer Only allows for L, N and switch lives for channels 1 - 4.
What do i do with the HW off wire???
I believe my system is a Y Plan from what i can see if this helps at all.
Many thanks
Richard
I am replacing an old APL lifestyle LP241 programmer with a new Heatmiser TM4 touchscreen. On the old timer plate has wires for L, N, HW on, HW off and CH on (CH off wire is not connected for some reason) although it all works as it should.
The new programmer Only allows for L, N and switch lives for channels 1 - 4.
What do i do with the HW off wire???
I believe my system is a Y Plan from what i can see if this helps at all.
Many thanks
Richard