Planning on getting a Monobloc Basin Mixer for our new bathroom.
HW from Cylinder, CW from mains.
Obviously the CW pressure is far in excess of the cold so presume I need a single check valve on the HW inlet to stop CW entering the HW system.
(HW) 15mm pipe ----> Isolation Valve ----> Check Valve -----> Flexi Tap Tail to Monobloc
(CW) 15mm pipe ----> Isolation Valve ----> Flexi Tap Tail to Monobloc
Mixer I was planning to use is this...
http://www.screwfix.com/app/sfd/cat...EVT0CSTHZPCFEY?cId=A341141&ts=80807&id=47934#
Is the above correct?
Thanks
Tom
HW from Cylinder, CW from mains.
Obviously the CW pressure is far in excess of the cold so presume I need a single check valve on the HW inlet to stop CW entering the HW system.
(HW) 15mm pipe ----> Isolation Valve ----> Check Valve -----> Flexi Tap Tail to Monobloc
(CW) 15mm pipe ----> Isolation Valve ----> Flexi Tap Tail to Monobloc
Mixer I was planning to use is this...
http://www.screwfix.com/app/sfd/cat...EVT0CSTHZPCFEY?cId=A341141&ts=80807&id=47934#
Is the above correct?
Thanks
Tom