Saturday i adjust the HL screws on the strimmer to do a job as it would rev properly.
Came to use it today but it bogs down when reving etc.
I adjust the H screw with the throttle wide open until it was sweet and used it for 1 hour
I need to use it again tomorrow on anothet job so will i need to adjust it again or should it work as is.
I seem to remember im doing this a few times now so wondering if there is an issue with different temps each day or maybe the mixture is slightly different each time.
Whats your verdict ?
Came to use it today but it bogs down when reving etc.
I adjust the H screw with the throttle wide open until it was sweet and used it for 1 hour
I need to use it again tomorrow on anothet job so will i need to adjust it again or should it work as is.
I seem to remember im doing this a few times now so wondering if there is an issue with different temps each day or maybe the mixture is slightly different each time.
Whats your verdict ?