Hi, Changing the kitchen appliances around and need to check what I need to do and what to ask for if I end up getting a sparky in.
Current setup: Cooker switch wired from separate 32amp breaker at board. Runs into back of isolator switch (with 13amp plug outlet) and then spurred down to a surface mounted 13A TSSO. One socket has the gas hob ignition feed plugged in and the other socket has my fan oven plugged in. The Fan oven is a Stoves SEB600FP and is rated for a 13A fuse. (ratings are Oven=2Kw, Grille= 1.85Kw but you can't have both on at the same time)
I take it that having both supplies on that 13A TSSO is ok as they are protected by their own fuses, which are lower than the 32A breaker.
New setup: I want to retain the Stoves unit mentioned above and add a Bosch HBC84H510B combi oven, which is rated at 16A and 3.6Kw. Both ovens will be mounted in a Wickes tower kitchen unit. The gas hob will be approx 650mm to the left of the oven tower. The isolator switch is midway between the two about 400mm off the worktop surface.
I also need to fit a new gas hob and will still need an ignition feed.
All wiring is in plastic trunking in the garage and enters the kitchen wall behind the units through double skin wall at the appropriate point.
What's the safest way to setup the wiring between the appliances and the isolator switch please?
Current setup: Cooker switch wired from separate 32amp breaker at board. Runs into back of isolator switch (with 13amp plug outlet) and then spurred down to a surface mounted 13A TSSO. One socket has the gas hob ignition feed plugged in and the other socket has my fan oven plugged in. The Fan oven is a Stoves SEB600FP and is rated for a 13A fuse. (ratings are Oven=2Kw, Grille= 1.85Kw but you can't have both on at the same time)
I take it that having both supplies on that 13A TSSO is ok as they are protected by their own fuses, which are lower than the 32A breaker.
New setup: I want to retain the Stoves unit mentioned above and add a Bosch HBC84H510B combi oven, which is rated at 16A and 3.6Kw. Both ovens will be mounted in a Wickes tower kitchen unit. The gas hob will be approx 650mm to the left of the oven tower. The isolator switch is midway between the two about 400mm off the worktop surface.
I also need to fit a new gas hob and will still need an ignition feed.
All wiring is in plastic trunking in the garage and enters the kitchen wall behind the units through double skin wall at the appropriate point.
What's the safest way to setup the wiring between the appliances and the isolator switch please?