Hi, when core drilling a hole for the toilet waste that exits at a right angle to the toilet so will be connected via a bent pan connector. What height should this be drilled? If a standard toilet outlet is 7.5 inch?
Centre the core between 5mm and 10 mm lower than the centre of the pan spigot and (assuming you're drilling from the inside) drill at a slight downward angle
Given that sanitary fittings seem to be coming from all over the place, I'd be inclined to select the pan first. As a general guide 180 mm to the centre line of the spigot but check before you core!
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local