Cutting Paving Slabs in a Wave

[Jetheat]

I'm having my patio made in the garden.

I have instructed the builders to make a wave design along the edge of the patio on one side.

So they have cut the slabs with a angle grinder in a wave shape, but it looks very rough and doesn't look nice.

Is there some sort of strip I can use to cover it or is there some other option I can take advantage of to make this clean?

Those edge slabs (with the wave) is sitting on a brick, which together is forming a step down.

Any ideas?

JH

 

[r896neo]

Get better builders. Whilst it is difficult to cut a tight internal arc, cutting gentle sweeping curves or externals arcs is relatively straight forward with a bit of experience.

Also its much easier on sandstone than it is on granite or pressed concrete for obvious reasons.

Best results are got when the flags are already laid. If cutting loosens them they need re-beded.

 

[Jetheat]

Is there some type of edging or cover I can put on their poor cuts?

 

[r896neo]

It will almost certainly be more effective to cut them again. trying to cover it with something may be very unusual looking and a trip hazard.

Any chance of a photo?