Ok gave in and brought a Plasplug 110mm diamond wheel tile cutter.
//www.diynot.com/forums/viewtopic.php?t=95945
Cuts quite nicely, only a small amount of chipping on the cut edges.
But when I get to about 15/10mm, as visible from the top of the tile it snaps and takes the corner of the tile with it, usually on the side furthest away from the guide, leaving me with a triangular corner rather than a nice square one. Have tried pushing with different pressures and resting it before getting to close to the end with no success.
What am I doing wrong and what’s the secret to getting square corners?
//www.diynot.com/forums/viewtopic.php?t=95945
Cuts quite nicely, only a small amount of chipping on the cut edges.
But when I get to about 15/10mm, as visible from the top of the tile it snaps and takes the corner of the tile with it, usually on the side furthest away from the guide, leaving me with a triangular corner rather than a nice square one. Have tried pushing with different pressures and resting it before getting to close to the end with no success.
What am I doing wrong and what’s the secret to getting square corners?