door bricked up with 4inch single skin on a 9inch house

Joined
22 Apr 2009
Messages
857
Reaction score
83
Location
Oxfordshire
Country
United Kingdom
Hi all,

Come across something i've been asked to sort for a customer i'm doing a stack of work for, they live in an edwardian place, 9inch solid walls, they've had the side door (external) bricked up in a single skin (4 inch) of soft reds to match the existing walls, this leaves a long corridor in the house now for them to put in a downstairs cloakroom with the loo backing onto the new bricked up doorway and the waste going out through it (already core drilled and 4inch waste goes into the new soil stack outside).

They want it all plastered now, i've pretty much done the whole house except for this little bit but i'm not sure what to do about the fact that it's a single skin (4inch) wall, shall i try and create a cavity with stud and vapour check board that i can insulate?

by the way, i'm only a spread, you know how these things go, customers see you're quite handy and have some knowledge and throw more and more at you until eventually you come across something you don't know how to tackle so thought i'd come to the obvious place.

any advice welcome and greatly appreciated.
 
Sponsored Links
Stick some Celotex in with some foam adhesive and board over it again stuck with foam adhesive.

Or make a timber frame, polythene one side, and then place the frame in with the polythene against the wall and screw the frame to the jambs. Then fill with quilt and board over it with foil backed board. Dont forget the DPC at the bottom
 
I'd either render the back of the bricks (and reveals) and tank with a cement product like Vandex or Sovereign, then use a Celotex and plasterboard or whatever finish you fancy. If you do go the timber frame route put the polythene on the inside not the outside face, building paper or breathable roofing felt is better on the outer face to minimise condensation.
 
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top