Hi all
Looking for some advice.
I recently purchased a Drayton Wiser kit 1 and I'm currently planning to have it fitted to our Worcester Greenstar 29CDi Classic Combi Boiler (manufactured Feb 2014)
The heating system is single zone.
I believe I'm confident with the wiring:
Ls & Ns taken from ST10 on boiler to pins L & N on the faceplate.
Link/Bridge Pins L(Live) & 1(Common) on the faceplate.
Wire Pin 3 (CH Demand) to LR (Switched Live) on ST10
However what I'm completely in the dark with is the following:
I have a LP10RF single channer clip-in hot water timer/control that also has an RF connection to the existing wireless Digistat. What do I do with the LP10RF to boiler wiring (or setup) to correctly disable the RF module whilst leaving the hot water control intact?
Addtional but probably non essential - are there any EMS to Opentherm adapters that could be used to 2 way tranlsate the different protocols to allow full opentherm integration with the Drayton Wiser or am I looking at a new boiiler for that level of functionality?
Many thanks in advance.
Looking for some advice.
I recently purchased a Drayton Wiser kit 1 and I'm currently planning to have it fitted to our Worcester Greenstar 29CDi Classic Combi Boiler (manufactured Feb 2014)
The heating system is single zone.
I believe I'm confident with the wiring:
Ls & Ns taken from ST10 on boiler to pins L & N on the faceplate.
Link/Bridge Pins L(Live) & 1(Common) on the faceplate.
Wire Pin 3 (CH Demand) to LR (Switched Live) on ST10
However what I'm completely in the dark with is the following:
I have a LP10RF single channer clip-in hot water timer/control that also has an RF connection to the existing wireless Digistat. What do I do with the LP10RF to boiler wiring (or setup) to correctly disable the RF module whilst leaving the hot water control intact?
Addtional but probably non essential - are there any EMS to Opentherm adapters that could be used to 2 way tranlsate the different protocols to allow full opentherm integration with the Drayton Wiser or am I looking at a new boiiler for that level of functionality?
Many thanks in advance.