a mate got let down by his sparks, fitting a eurosec cpx alarm panel. All wires have been run to pirs and contact switches back to the panel.
There's a honeywell bellbox sitting in a box too.
1) I was wondering which panel terminals match with the bellbox.
on the panel I have
SAB TMP
BELL+
BELLHOLD
BELL-
STROBE-
on the bellbox I have
R
V+
SW
V-
ST
I've fitted the odd Optima alarm panel (very straight forward) before but this has a 100+ pages of just programming :-/
2) I'm presuming the basics here,
power feed for the PIR's is from the aux 12v +&-
pir and door contact switches go to AZ1 to AZ8
tamper ccts wired in series to TZ
3) none of this requiring the supplied resistors ?
Any help to the above, as always, appreciated.
i'd post a link to the installation PDF but risco have restricted access !
There's a honeywell bellbox sitting in a box too.
1) I was wondering which panel terminals match with the bellbox.
on the panel I have
SAB TMP
BELL+
BELLHOLD
BELL-
STROBE-
on the bellbox I have
R
V+
SW
V-
ST
I've fitted the odd Optima alarm panel (very straight forward) before but this has a 100+ pages of just programming :-/
2) I'm presuming the basics here,
power feed for the PIR's is from the aux 12v +&-
pir and door contact switches go to AZ1 to AZ8
tamper ccts wired in series to TZ
3) none of this requiring the supplied resistors ?
Any help to the above, as always, appreciated.
i'd post a link to the installation PDF but risco have restricted access !