Can also clean the green residue of the copper fittings! That will be an improvement! Though it does looks like it's ready to pop anyway!Basically there's a lot you can do to get rid of that eyesore.
If you are renovating, and can drain the CH down then you could cut the pipe and put one of these in: http://www.earthcrimp.co.uk/[/QUOTE]
What is the advantage of that over a more conventionally attached earth point?
Daniel
If you are renovating, and can drain the CH down then you could cut the pipe and put one of these in: http://www.earthcrimp.co.uk/[/QUOTE]
What is the advantage of that over a more conventionally attached earth point?
Daniel
Its a combination of crimped and soldered, therefore does NOT need to be accessible and can be located under the floorboards out of sight.
Ahhh! Fair enough.... therefore does NOT need to be accessible ...
If you fit an end-feed one I strongly suggest soldering both ends, not just one as in their video.
Plumbers, eh?
If you fit an end-feed one I strongly suggest soldering both ends, not just one as in their video.
Plumbers, eh?
And burn dressings.So you can add solder, blow torch, heat mat, flux, wire wool, fire extinguisher and wipes to your tool kit!
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local