- Joined
- 2 Jun 2004
- Messages
- 30
- Reaction score
- 2
- Country
I have a room in a 1930 house which i am renovating, which has a tongue and groove wooden floor.
The issue is that there are 3-5mm gaps between the T&G boards that collect a load of crap and makes it a pain to clean.
It is varnished and as part of the renovation i am going to sand it back and re-finish. While i am doing this i want to fill the gaps, then varnish / vax over flush.
The filling isn't to stop drafts as its T&G and has taped PIR boards between the joist underneath, its just there to look a bit better and make the surface flush.
Any ideas for filler, i am thinking that it needs to be a bit flexible.
The issue is that there are 3-5mm gaps between the T&G boards that collect a load of crap and makes it a pain to clean.
It is varnished and as part of the renovation i am going to sand it back and re-finish. While i am doing this i want to fill the gaps, then varnish / vax over flush.
The filling isn't to stop drafts as its T&G and has taped PIR boards between the joist underneath, its just there to look a bit better and make the surface flush.
Any ideas for filler, i am thinking that it needs to be a bit flexible.