- Joined
- 19 Jan 2005
- Messages
- 1,171
- Reaction score
- 41
- Country
HI everyone
I need to fit a lid to an existing section of 6" galv trunking. The problem is that the turnbuckles that come with the new lid are too small and won't 'catch' over the end of the trunking lip (it old, so quite thick).
What I need is the old style turn buckle that runs the width of the trunking and you turn via a screw on the outside and it spins to catch on the inside of the trunking. Hope this makes sense!
I've searched online but can only find the one that the lid came with
Any ideas?
Thanks
SB
I need to fit a lid to an existing section of 6" galv trunking. The problem is that the turnbuckles that come with the new lid are too small and won't 'catch' over the end of the trunking lip (it old, so quite thick).
What I need is the old style turn buckle that runs the width of the trunking and you turn via a screw on the outside and it spins to catch on the inside of the trunking. Hope this makes sense!
I've searched online but can only find the one that the lid came with
Any ideas?
Thanks
SB