The seal around my bath is very discoloured and needs to be replaced (starting to leak). Problem is that where the edge of the bath meets the wall the sealant strip looks to be plastered to the wall, and matches up to the bottom of the lower set of tiles.
If I remove this seal I will have a 1inch gap between the edge of the bath and the tiles, water will have no problem getting through this. A builder recommended re-tiling the entire wall, on top of the existing tiles so that the new row of tiles can be matched up to the bath, leaving a small gap which can just be filled with a small amount of silicon sealant.
Don't really want to have the entire wall retiled, any other suggestions?
If I remove this seal I will have a 1inch gap between the edge of the bath and the tiles, water will have no problem getting through this. A builder recommended re-tiling the entire wall, on top of the existing tiles so that the new row of tiles can be matched up to the bath, leaving a small gap which can just be filled with a small amount of silicon sealant.
Don't really want to have the entire wall retiled, any other suggestions?