gas fire will not ignite when control knob turned. a spark is evident when knob turned. it lights when you use a lighter and stays lit. cleaned around area of spark, no improvement. any advice
it sounds like the fire is fitted with an oxysafe pilot assembly and this is a fault that can appear when the fire needs service just under the oxypilot there is a smalll filter that gets fluffed up and does not let enough gas out to be lit with the spark device even though you can light it with a match get it seviced remove the burner and get it done properly it could save your life one day use a corgi eng to have it done
ok gasmick, good points. its my mums fire so need to use a corgi guy for her safety, needed to have some idea of what maybe wrong, any recommendations of a reasonably priced fitter in the prescot, knowsley area who will assist.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local