Hi.. i've had a bad experience with brush on silver metallic hemmerite. no one told me this stuff can run for England. Horizontal surfaces were fine, anything else and it just would not stop running as soon as i got any on. It was a small area (an electrics box) so should have been easy but even with me keep going back and catching the runs as i went it seemed unavoidable. So i've left it to dry now and sure enough there are lots of clear runs.. question is, will i be able to sand these area's back, retouch and still get a good finish? How long would i need to leave it first? Do you need special powers to apply this stuff?
thanks!
thanks!