Hope someone can shed light on this one!!
Fully rewired a semi and new 100amp supply installed by authority.
A circular saw is being used next door which is also being refurbished/rewired.
The rewire here is virtually complete except for a couple of customer fittings.
When the circular saw is powered up it sometimes trips the RCD next door!!
I thought it was a wind up but the project manager is tearing his hair out!
I cant get back on site till tommorrow ..... any ideas????
Low voltage???
Fully rewired a semi and new 100amp supply installed by authority.
A circular saw is being used next door which is also being refurbished/rewired.
The rewire here is virtually complete except for a couple of customer fittings.
When the circular saw is powered up it sometimes trips the RCD next door!!
I thought it was a wind up but the project manager is tearing his hair out!
I cant get back on site till tommorrow ..... any ideas????
Low voltage???