Hi all
A few months ago when the technicians came to rewire the electrical system, they were leaving an "elbow" of wire about 1 inch off the ceiling, I always thought it would be a surplus of old phone line, so that when it was time to paint the lounge I remove the plaster to cut the cable and fix the issue!
The wire turned out to be a PIR , immediately I hear a sound from the Remote keypad, in which the "tamper" light was on, so I soldered the wires, which silence the alarm, but when I try to check that everything was fine, I have areas 2,3,4 lit and a bep-bep-bep bep.
I download the "Engineering Information" Manual but I still don't know best way to proceed.
Alarm System: Accenta mini G3 panel with LED remote keypad.
In advance thank you for your advice.
Jorge
A few months ago when the technicians came to rewire the electrical system, they were leaving an "elbow" of wire about 1 inch off the ceiling, I always thought it would be a surplus of old phone line, so that when it was time to paint the lounge I remove the plaster to cut the cable and fix the issue!
The wire turned out to be a PIR , immediately I hear a sound from the Remote keypad, in which the "tamper" light was on, so I soldered the wires, which silence the alarm, but when I try to check that everything was fine, I have areas 2,3,4 lit and a bep-bep-bep bep.
I download the "Engineering Information" Manual but I still don't know best way to proceed.
Alarm System: Accenta mini G3 panel with LED remote keypad.
In advance thank you for your advice.
Jorge