i apologise if this has been asked before but I've searched threads without success.
I decided to buy a Veritas panel to fit in my sister's home out in Malaysia (the locally available panels don't look as good as the Texecom panels). I brought it out on holiday this week.
It's all wired up using 2 LCD keypads, bell box and detectors. When switched on, a tamper fault is displayed on keypads.
I've looked in the manual at 'trouble shooting' and it refers to removing links but doesn't really further explain which links, if any.
Can anyone advise please? 4 wire cable has been used for the keypads (X 2) and sensors (7 sensors each assigned a zone and wired to their own zone) and 6 wire cable for the bell box.
I've also not yet fitted a battery as I wasn't sure I could take one on the plane, so I'm going to source something locally which suits (12v 2.1ah or thereabouts). Is it ok to use the panel without the battery for now? I assume the battery just provides power if mains is interrupted?
Many thanks in advance for any advice you can offer.
Malaysia
I decided to buy a Veritas panel to fit in my sister's home out in Malaysia (the locally available panels don't look as good as the Texecom panels). I brought it out on holiday this week.
It's all wired up using 2 LCD keypads, bell box and detectors. When switched on, a tamper fault is displayed on keypads.
I've looked in the manual at 'trouble shooting' and it refers to removing links but doesn't really further explain which links, if any.
Can anyone advise please? 4 wire cable has been used for the keypads (X 2) and sensors (7 sensors each assigned a zone and wired to their own zone) and 6 wire cable for the bell box.
I've also not yet fitted a battery as I wasn't sure I could take one on the plane, so I'm going to source something locally which suits (12v 2.1ah or thereabouts). Is it ok to use the panel without the battery for now? I assume the battery just provides power if mains is interrupted?
Many thanks in advance for any advice you can offer.
Malaysia
Last edited by a moderator: